Ham Radio Programming Software License About A

Well assume youre ok with this, but you can opt-out if you wish.

It has a bad screen (vertical line), but it will work for what I need it for.

Ham Radio iMac (iCOM Macintosh) is what Im calling it and its attached to my Icom 7300 This is not going to replace my PC, but it will be fun to use.

I agree to have my personal information transfered to MailChimp ( more information ) Receive e-mail notifications of new articles.

I saw a video on YouTube with RUMLogNG displaying the Icom 7300s bandscope on the monitor.

It also boasts two other neat features that are hard to explain, so Ill just have to show you.

It is a paid application however (95), so Ill have to look at that one a little harder.

MenuSetConnectors Please help by sharing Share on Facebook Share on Twitter Share on Reddit.

I love the hobby and experimenting with radios, antennas and software.

On my YouTube channel I upload videos on the Icom 7300 and Icom 7610 along with Ham radio software programs.

May try a powered usb hub between the 7300 and Imac late 2009.

Also, Ive heard the SLAB driver is not signed, so it may have a deeper problem.

Change USB Audio CODEC to 2 ch 16-bit Integer 44.1kHz You can find the MIDI setup in Applications and Utilities.

Ive looked at some of your videos, but wonder is there a way to use an IMAC (27 3.4 GHZ 17.

GB 1333 MHZ DDR Graphics Radeon HD 6970 M 2048 MB) hooked up to a RSP1 sdr instead of a PC to run a IC 7300 Reply.

There is also MacLoggerDX which cost some, but it is very good and worth it in my opinion.

I would check out RumLogNG first though, it has the spectrum scope.

See this article: Ham Radio iMac (iCOM Macintosh) In The Shack Theres more too, just look under the Mac category on the right hand side.

You could try CubicSDR, it worked for me and the SDR dongle I had.

Ham Radio Programming Software License About A

Just got my General license about a month ago and got an IC-7300.

Have been meaning to get my 7300 connected to my Mac but didnt know how.

Because of my experience, it would have taken me hours to figure it out.

Thanks.

Thank you so much for your input, I really do appreciate it and glad it helped.

I can FT with my macbook and IC7300, I can FT8CALL, I want to be able to send APRS data is there any instruction on how to do that, I have FIDIGI running too.

In order to post comments, please make sure JavaScript and Cookies are enabled, and reload the page.

Click here for instructions on how to enable JavaScript in your browser.

Ham Radio Programming Software For Mac